Tele Knox New Style Glueless Clamp Set

These will fit old Tele-Knox rods. Just remove old clamps by using heat gun or similar to melt the glue. These do not need Gluing. These clamps come pretty much set ready to go. Put the Clamps on the rod (no need to clean old glue off) Put the three rods together with the clamps on before tightening to the point where they grip just. Up and down slide movement can be controlled by the finger knob but again not too tight. Just a small adjustment at a time when necessary.

PLEASE NOTE OUR RECOMMENDATION NOW IS TO PUT THESE NEW CLAMPS IN A POSITION 180 DEGREES AWAY FROM THE ANTI ROTATION CHANNEL RATHER THAN INLINE WITH IT. THIS WILL HELP WITH THE OVER-TIGHTENING PROBLEM SOME PEOPLE HAD. Problems with the old clamps were caused by over tightening the clamps and cracking the Carbon shaft causing the clamps to loosen.